2.12.3. Removal, installation and tension of a maple gear belt

Since September, 1992 some 4-cylinder engines are equipped instead of maple belts with maple gear belts.

Check and adjustment of maple gear belts is not required, as the sprung, tension device automatically supports the correct tension of a belt.

Removal

PERFORMANCE ORDER
1. Before removal to notice the direction of the movement of a maple belt. For this purpose to apply on it with a fatty pencil an arrow.
2. To turn the lever of a tension roller by means of mount or the big screw-driver against action of a tension spring and to take off maple a gear belt.
2,0 l petrol engine (AAS)
3. To establish mount between two ledges of an uspokoitel of a natyazhitel of a belt and to turn a tension roller to the right until maple the gear belt does not weaken so that it can be removed from a tension roller. Then to weaken from above an uspokoitel of a natyazhitel of a belt and to take off maple a gear belt.

Installation

PERFORMANCE ORDER
1. If the old belt is established, to pay attention to the direction of its old movement. It has to be established only in this direction.
2. To put on maple a gear belt. To turn the lever of a tension roller by means of mount or the big screw-driver aside opposite to action of a tension spring and to put on a belt a tension roller. Then slowly to release a natyazhitel of a belt.
2,0 l petrol engine (AAS)
3. To clamp an uspokoitel of a natyazhitel of a belt.

CARS WITHOUT TENSION ROLLER

Removal and installation

PERFORMANCE ORDER
1. To weaken bolts of fastening of the generator.
2. To wring out the generator mount down.
3. To remove or put on maple a gear belt.
4. After installation of a maple gear belt to scroll the engine at the weakened generator several times (about 10 turns). For an engine provorachivaniye a starter use assistance. At the same time the transmission has to be in neutral situation, the emergency brake is tightened.
5. To tighten generator screws the moment of 25 N · m.