2.14.4. Check of the transformer of high voltage
The transformer of high voltage is in a motor compartment under a protection in front of the rechargeable battery at the left, the transformer includes the ignition coil, the device of switching off and a final step of power which are in one case.
4-and 5-cylinder engine
PERFORMANCE ORDER |
1. To disconnect the connecting plug and a wire of high voltage from the transformer. |
Check of resistance of primary winding of the coil of ignition |
|
2. To connect an ohmmeter to plugs 1 and 15. |
3. The required value: 0,5–0,7 Ohms. |
4. If the received value does not correspond demanded, the transformer to replace. |
Check of resistance of a secondary winding of the coil of ignition |
5. To connect an ohmmeter to plugs 15 and 4. |
6. The required value: 3–4 kOhm. |
7. If the received value does not correspond demanded, the transformer to replace. |
|
8. To connect the voltmeter to contacts 1 and 3 (-) of the plug (4). |
9. To include ignition. The required value: voltage of the rechargeable battery is 12–14 Century. If necessary to eliminate break in conducting according to the electrical circuitry. |
10. To switch off ignition, to disconnect the voltmeter. |
Work check |
11. To disconnect the plug of the valve of cold start and multicontact connection of the injecting valves. |
|
12. To connect the diode indicator to contacts 2 and 3 plugs (4). |
Prevention
During this check not to touch by a hand of the connected parts of the transformer of high voltage and wires of the indicator.
|
13. To include a starter. |
14. The light-emitting diode has to blink. |
15. Otherwise to check Hall's sensor. |
16. If malfunction is not found, obviously, the Digifant monitor is faulty. |
17. To switch off ignition. |
18. To connect the threefold plug to the transformer. |
|
Only the 4-cylinder engine
PERFORMANCE ORDER |
1. To connect the voltmeter to transformer plugs 1 and 15. |
2. To include ignition. |
3. The required value: not less than 2 V, later 1–2 sec. have to fall up to 0 Century. Otherwise to replace the transformer. |
4. To connect the plug to the valve of cold start and multicontact connection of the injecting valves. |
|