2.17.5. Rope of a butterfly valve
Adjustment of a rope of a butterfly valve (4-cylinder petrol engine)
1. Branch pipe of a butterfly valve
2. Stopper
3. Rope of a butterfly valve
4. Rubber plug
|
5. Accelerator pedal
6. Sliding bearing
7. Stopper
8. Accelerator pedal support |
Prevention
The rope is very susceptible to changes therefore it at installation demands very careful address. Even the small break can lead to break during operation. Not to establish the Nadlomanny rope.
Adjustment
| PERFORMANCE ORDER |
| 1. To squeeze out a pedal in the provision of full gas and to hold it in this situation. It is possible to use assistance. |
| 2. To check whether there is a lever of a butterfly valve in the provision of full gas for a butterfly valve. |
|
|
3. Otherwise to take out a lock plate (1), to extend a rope against the stop of the lever of a butterfly valve, at the same time the butterfly valve is in the provision of full gas. In this situation to insert a lock bracket into place. At the correct adjustment between the lever of a butterfly valve and an emphasis there has to be a small gap which is not exceeding 1 mm (the lock screw (3), a lock washer (2)). |
|
Removal
| PERFORMANCE ORDER |
| 1. To remove a rope from the lever, an emphasis and a butterfly valve. |
| 2. To break off an emphasis from salon. |
| 3. To take out the damaged rope towards a motor compartment |
|