1. Operational development of a head of the block of cylinders of the diesel engine is inadmissible. |
|
2. When replacing laying to pay attention to designation and to establish new laying of the same designation. Designation of laying of a head of the block of cylinders with openings and notches (shooter) is visible as well at the established head of the block of cylinders. Depending on a vystupaniye of pistons laying of a head of the block of cylinders of various thickness is established. |
3. To replace laying of a head of the block of cylinders always. At the same time new laying has to have the same designation, as old. Only after installation of new pistons or a part of the engine it is possible to measure a new vystupaniye of pistons and to determine the new thickness of laying. |
Prevention
To replace bolts of a head of the block of cylinders always.
|
4. Bolts of a head of the block of cylinders of the diesel engine drag on also, as well as on the petrol engine. However bolts of a head of the block of cylinders of the diesel engine are in addition tightened on the warm engine. |
5. To establish heat candles (see subsection 2.17.7.2). |
6. To establish nozzles (see subsection 2.17.7.5). |
7. To clean connections of the giving pipelines means of cold cleaning. To tighten cap nuts the moment of 25 N · m. |
8. To put on a hose of return of fuel a nozzle of the 5th cylinder. |
9. To establish both gear belts (see subsection 2.5.2.1). |
10. To put on a vacuum hose of the amplifier of brakes the vacuum pump sideways on a head of the block of cylinders and to fix by a collar. |
11. To put on a thin hose of cooling liquid near the 1st cylinder over an inlet collector and to fix by a collar. |
12. To put on a hose of cooling liquid a connecting branch pipe on a head of the block of cylinders over the case of the thermostat and to fix by a collar. |
13. To check the beginning of giving of TNVD (see subsection 2.17.7.6). |
Prevention
To tighten bolts of a head of the block of cylinders on the warm engine.
|
14. To warm up the engine, the fan will not turn on yet. |
15. To uncover a head of the block of cylinders. |
16. To tighten all bolts of a head of the block of cylinders in accordance with the established procedure (see rice. An order of an inhaling of bolts of a head of the block of cylinders) a rigid key without preliminary easing and at one time on 1/4 turns (90 °). |
Prevention
Further tightening of bolts of a head of the block of cylinders after 1000 km of a run is inadmissible.
|
17. To establish a cover of a head of the block of cylinders. |