9.17.2. Heater motor

Removal

PERFORMANCE ORDER
1. To disconnect a weight(s) cable from the rechargeable battery.
Prevention

At the same time from memory of the radio receiver the anticreeping code is erased. It is impossible to disconnect the rechargeable battery at the included ignition. Otherwise, the control unit of system of injection will fail.
2. To remove inlet branch pipes.
3. To check ease of the course of a krylchatka of the fan in the established state.
4. To remove a ware box.
5. To remove the right air duct (see rice. Device of system of heating).
6. To disconnect the plug on the case.
7. If the motor of a heater works not at all steps that preliminary resistance is, as a rule, faulty. In this case to replace a connecting payment, having unscrewed the screw (2).
8. To wring out down the screw-driver lock uvulas (4). To turn a heater motor clockwise, to remove in the middle of a guard of devices and to take out.
9. To take out the available foreign objects from the vozdukhovodny channel.

Installation

PERFORMANCE ORDER
1. To establish and screw a connecting payment.
2. To establish a heater motor, to turn to the left and to stop.
3. To connect the plug.
4. To connect a cable of weight(s) and to check work of a motor of a heater.
Prevention

To connect the rechargeable battery only at the switched-off ignition, otherwise the control unit of system of injection will fail.
5. To expose hours.
6. To enter into the radio receiver an anticreeping code (see subsection 10.19.11).
7. To establish an air duct.
8. To establish inlet branch pipes.
9. To establish a ware box.