| 1. Operational development of a head of the block of cylinders of the diesel engine is inadmissible. |
|
|
2. Depending on a vystupaniye of pistons laying of a head of the block of cylinders of various thickness is established. When replacing laying to pay attention to designation of old laying and to establish new laying with the same designation. A black arrow – number of the spare part, a white arrow – cuts / opening. |
| |
3. Before installation of a head of the block of cylinders to screw in in external openings from the inside the directing fingers 3070. |
| 4. If near at hand there are no guides of pins, to make the directing pins for centering of a head of the block of cylinders. For this purpose to saw off heads at old bolts of a head of the block of cylinders and to saw through a groove under the screw-driver. |
| 5. To screw in the directing pins in openings 8 and 10 (see subsection 2.6.1). To turn the crankshaft for a belt pulley so that all pistons rose approximately at identical height. |
| 6. To establish a head of the block of cylinders. |
| 7. To establish the remained 8 bolts of a head of the block of cylinders with podkladny washers and to tighten by hand. To replace bolts of a head of the block of cylinders always. |
| 8. To unscrew the directing pins the screw-driver, to establish the remained 2 bolts of a head of the block of cylinders with lining washers and to tighten by hand. |
| 9. Bolts of a head of the block of cylinders of the diesel engine drag on also, as well as at the petrol engine, but besides, in addition, are tightened once again on the warm engine. |
| 10. To replace laying of a cover of a head of the block of cylinders only at damage. |
| 11. To establish glow plugs (see subsection 2.17.7.2). |
| 12. To establish nozzles (see subsection 2.17.7.5). |
| 13. To clean means of cold cleaning of connection of the bringing pipelines. To tighten cap nuts the moment of 25 N · m. |
| 14. To connect wires to the switch of supply of fuel and glow plugs. |
| 15. To check the beginning of giving of the fuel pump of high pressure (see subsection 2.17.7.6). |
| 16. To tighten bolts of a head of the block of cylinders on the warm engine. For this purpose to warm up the engine in the movement, to leave to work at single turns the radiator fan will not turn on yet (temperature of oil higher 50 °). |
| 17. To stop the engine. |
| 18. To unscrew a cover of a head of the block of cylinders. |
| 19. To tighten bolts a rigid key, without preliminary easing and at one time on 1/4 turns (90 °). To observe the sequence of an inhaling (see rice. Order of an inhaling of bolts of a head of the block of cylinders). |
| 20. To establish a cover of a head of the block of cylinders. |
Prevention
Dozatyazhka of bolts of a head of the block of cylinders after 1000 km of a run is inadmissible.
|