2.14.5. Check of the sensor of Hall
Verification of an overdressing
PERFORMANCE ORDER |
1. To disconnect the plug of the sensor of Hall (on the ignition distributor). |
|
2. To connect the voltmeter to external contacts. |
3. To include ignition. |
4. The required value: not less than 10 Century. Otherwise the monitor is faulty. |
5. To switch off ignition. |
|
Work check
PERFORMANCE ORDER |
1. To disconnect the plug of the valve of cold start and the multicontact plug of the injecting valves. |
2. To remove a rubber nozzle of the plug from Hall's sensor and to disconnect the sensor plug. |
|
3. To connect the diode indicator to average and external wires of the plug of the sensor of Hall. |
Prevention
During this check not to touch by a hand of the connected parts of the transformer and wires of the indicator.
|
4. To include a starter. |
5. The light-emitting diode has to blink, otherwise Hall's sensor is faulty. In this case at the 4-cylinder engine to replace the ignition distributor, at the 5-cylinder engine to disassemble the distributor of ignition and to replace Hall's sensor. |
6. To connect the plug of the valve of cold start and multicontact connection of the injecting valves. |
|